Home › Drivetrain › U660F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM3090E _52 Drivetrain _008436 U660F AUTOMATIC TRANSMISSION / TRANSAXLE _0047086 PARK / NEUTRAL POSITION SWITCH G

U660F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSPECTION  


PROCEDURE

Hide 84540 1.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

C197712C20
1.833,0.938 2.229,0.385 true 1.604,0.927 1.729,0.375 true 1.281,0.958 0.99,0.458 true 1.052,1.625 1.344,1.292 true 2.052,1.615 1.698,1.302 true 0.083,0.094 0.396,0.292 0.313,0.198 10 *a 2.271,0.26 2.583,0.458 0.313,0.198 10 RB 2.125,1.583 2.365,1.781 0.24,0.198 10 DL 0.854,0.344 1.094,0.542 0.24,0.198 10 B 0.938,1.583 1.177,1.781 0.24,0.198 10 L 1.771,0.26 2.01,0.458 0.24,0.198 10 RL
*a Component without harness connected
(Park/Neutral Position Switch Assembly)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (B) - 9 (L) Shift lever in P Below 1 Ω
1 (RB) - 2 (RL) Shift lever in R Below 1 Ω
4 (B) - 9 (L) Shift lever in N Below 1 Ω
1 (RB) - 7 (DL) Shift lever in D, M, "+"or "-" Below 1 Ω
4 (B) - 9 (L) Shift lever not in R 10 kΩ or higher
1 (RB) - 2 (RL) Shift lever not in R 10 kΩ or higher
4 (B) - 9 (L) Shift lever not in N 10 kΩ or higher
1 (RB) - 7 (DL) Shift lever not in D, M,"+" or "-" 10 kΩ or higher


If the resistance value is not as specified, replace the park/neutral position switch assembly.