Home › Drivetrain › U660F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM3090E _52 Drivetrain _008436 U660F AUTOMATIC TRANSMISSION / TRANSAXLE _0047086 PARK / NEUTRAL POSITION SWITCH A

U660F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 17705 2.REMOVE AIR CLEANER CAP AND HOSE

Hide 17801 3.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 4.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 5.DISCONNECT FUEL FILTER ASSEMBLY

C209708

a.

Disconnect the connector and detach the connector clamp.


b.

Remove the bolt and slide the fuel filter assembly upward to disconnect it from the air cleaner bracket.


Hide 17119A 6.REMOVE AIR CLEANER BRACKET

a.
A208834

Remove the 2 nuts and air cleaner support.


b.
C209709

Disconnect the glow relay.


c.
A208835

Detach the 3 wire harness clamps.


d.

Detach the 2 fuel hoses from the air cleaner bracket.


e.

Remove the 3 bolts and air cleaner bracket.


Hide 33820B 7.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

C132236

a.

Move the shift lever to N.


b.

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


Hide 84540 8.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Disconnect the park/neutral position switch connector.


b.
C136685

Remove the nut, washer and control shaft lever from the control shaft.


c.
C135732

Remove the 2 bolts and pull out the park/neutral position switch assembly to remove it from the control shaft.

NOTICE:

Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.