Home › Drivetrain › U660F AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER
RM3090E _52 Drivetrain _008436 U660F AUTOMATIC TRANSMISSION / TRANSAXLE _0047088 SHIFT LEVER A

U660F AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD vehicles and LHD vehicles.


·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C203403

Disconnect the end of the transmission control cable assembly from the shift lever assembly.


c.
C127813C01
1.823,0.656 2.146,0.135 2.146,0.135 2.24,0.135 true 1.385,1.406 1.219,1.74 1.219,1.74 1.094,1.74 true 0.938,1.667 1.104,1.833 0.167,0.167 10 *2 2.281,0.042 2.833,0.229 0.552,0.188 10 *1
*1 Stopper
*2 Nut


Pull out the stopper of the transmission control cable assembly.


d.

Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.

NOTICE:

Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.



Hide 3.REMOVE SHIFT LEVER ASSEMBLY

a.

Disconnect the 2 connectors and 4 clamps from the shift lever assembly.

C279459C01
0.375,0.01 0.688,0.167 0.313,0.156 10 *A 3.969,0.021 4.281,0.177 0.313,0.156 10 *B
*A for LHD *B for RHD



b.
C278536

Remove the 4 bolts and shift lever assembly.