84610F
1.INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY
| *a | LH |
| *b | RH |
| *c | Component without wire harness connected
(Transmission Shift Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Shift Position | Specified Condition |
|---|---|---|
| SFTD - ECC | "-" shift paddle operated and held (down-shift) | Below 2.5 Ω |
| SFTD - ECC1 | "-" shift paddle operated and held (down-shift) | Below 2.5 Ω |
| SFTD - ECC | "-" shift paddle not operated (down-shift) | 1 MΩ or higher |
| SFTD - ECC1 | "-" shift paddle not operated (down-shift) | 1 MΩ or higher |
| Tester Connection | Shift Position | Specified Condition |
|---|---|---|
| SFTU - ECC | "+" shift paddle operated and held (up-shift) | Below 2.5 Ω |
| SFTU - ECC | "+" shift paddle not operated (up-shift) | 1 MΩ or higher |
If the result is not as specified, replace the transmission shift switch assembly.
84523
2.INSPECT NO. 1 SWITCH WIRE
Connect the No. 1 switch wire connector to the transmission shift switch assembly.
Disconnect the steering pad switch connector from the No. 1 switch wire.
| *a | Component without wire harness connected
(No. 1 Switch Wire) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| SFTD - ECC | "-" shift paddle operated and held (down-shift) | Below 2.5 Ω |
| SFTU - ECC | "+" shift paddle operated and held (up-shift) | Below 2.5 Ω |
| SFTD - ECC | "-" shift paddle not operated (down-shift) | 1 MΩ or higher |
| SFTU - ECC | "+" shift paddle not operated (up-shift) | 1 MΩ or higher |
If the result is not as specified, replace the No. 1 switch wire.