Use the following procedure to troubleshoot the Toyota parking assist-sensor system.
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| Symptom does not occur |
| Symptom occurs |
Symptom does not occur
Symptom occurs
Refer to Symptom Simulation.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Result |
|---|
| NEXT |
NEXT
Refer to the Problem Symptoms Table.
| Proceed to |
|---|
| Fault is not listed in Problem Symptoms Table |
| Fault is listed in Problem Symptoms Table |
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT