Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2012.12–2015.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0047058 BLIND SPOT MONITOR SYSTEM D

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  DTC CHECK / CLEAR  


CHECK DTC


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the blind spot monitor main switch (warning canceling switch assembly*1 or telltale light assembly*2) on.

*1: for LHD

*2: for RHD



d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Trouble Codes.

HINT:

The blind spot monitor sensor RH and the blind spot monitor sensor LH both output DTCs. Therefore, check both blind spot monitor sensors for DTCs.



f.

Check for DTCs.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314


CLEAR DTC


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the blind spot monitor main switch (warning cancel switch assembly*1 or telltale light assembly*2) on.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Trouble Codes.


f.

Clear the DTCs.

Body Electrical > Blind Spot Monitor Master > Clear DTCs
50002 313
Body Electrical > Blind Spot Monitor Slave > Clear DTCs
50002 314