Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2012.12–2015.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0047058 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0142  Lost Communication with Body Control Module "B"  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.

HINT:

If CAN communication system DTCs are stored, they may also be stored for other systems.


DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" Lost communication with ECM CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with spiral cable with sensor sub-assembly CAN communication system
U0129 Lost Communication with Brake System Control Module Lost communication with vehicle stability control system CAN communication system
U0142 Lost Communication with Body Control Module "B" Lost communication with main body ECU (multiplex network body ECU) CAN communication system

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (warning cancel switch assembly*1 or telltale light assembly*2) is on.

*1: for LHD

*2: for RHD



PROCEDURE

1.CHECK DTC

b.

Check for DTCs.

for LHD (Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>HOW TO PROCEED WITH TROUBLESHOOTING)

for RHD (Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>HOW TO PROCEED WITH TROUBLESHOOTING)

Result:
Proceed to
DTCs are not output
DTCs are output (for LHD)
DTCs are output (for RHD)


HINT:
·

If CAN communication system DTCs are stored, they may also be stored for other systems.

·

If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING





DTCs are not output

DTCs are output (for LHD)

DTCs are output (for RHD)