Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2012.12–2015.10
RM3090E _58 Vehicle Interior _008429 LIGHTING (INT) _0047052 LIGHTING SYSTEM J

LIGHTING (INT)  LIGHTING SYSTEM  Engine Switch Illumination Circuit  


DESCRIPTION

The illuminated entry system controls the engine switch illumination.

WIRING DIAGRAM

E270728E01
5.438,2.115 6.948,2.583 1.51,0.469 10 Certification ECU (Smart Key ECU Assembly) 1.844,0.635 2.333,0.833 0.49,0.198 10 SWIL 1.792,1.323 2.281,1.521 0.49,0.198 10 AGND 2.271,0.635 2.51,0.823 0.24,0.188 10 9 2.271,1.323 2.51,1.51 0.24,0.188 10 6 0.281,1.885 0.594,2.063 0.313,0.177 10 G24 0.292,2.031 1.302,2.26 1.01,0.229 10 Engine Switch 5.656,0.635 5.896,0.823 0.24,0.188 10 16 5.656,1.333 5.896,1.521 0.24,0.188 10 24 5.427,1.938 5.792,2.125 0.365,0.188 10 G84 5.896,1.438 6.385,1.635 0.49,0.198 10 AGND 5.896,0.74 6.385,0.938 0.49,0.198 10 SWIL

PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (ENGINE SWITCH)
a.

Using the GTS, perform the Active Test.

Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Entry&Start > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Power/Engine SW Light Engine switch Illumination ON or OFF -
Body Electrical > Entry&Start > Active Test
Tester Display
Power/Engine SW Light
50004 125 27

Result:
Proceed to
Engine switch illumination illuminates
Engine switch illumination does not illuminates



Engine switch illumination illuminates

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Engine switch illumination does not illuminates

2.INSPECT ENGINE SWITCH
2.INSPECT ENGINE SWITCH

OK

3.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY])

NG

3.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY])
a.

Disconnect the G24 engine switch connector.


b.

Disconnect the G84 main body ECU (multiplex network body ECU) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G24-9 (SWIL) - G84-16 (SWIL) Always Below 1 Ω
G24-6 (AGND) - G84-24 (AGND) Always Below 1 Ω
G24-9 (SWIL) - Body ground Always 10 kΩ or higher
G24-6 (AGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR