Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0047053 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Headlight Relay Circuit  


DESCRIPTION

The main body ECU (multiplex network body ECU) receives headlight dimmer switch information signals and illuminates the low beam headlights.

WIRING DIAGRAM

E270895E01
2.854,0.438 3.729,0.615 0.875,0.177 10 from Battery 3.083,1.542 3.927,1.729 0.844,0.188 10 H-LP LH-LO 0.823,1.25 2.542,1.594 1.719,0.344 10 Headlight Light Control ECU Sub-assembly LH 0.865,4.25 2.583,4.594 1.719,0.344 10 Headlight Light Control ECU Sub-assembly RH 0.688,2.167 2.656,2.344 1.969,0.177 10 Discharge Headlight Bulb (Low) 0.677,5.198 2.646,5.375 1.969,0.177 10 Discharge Headlight Bulb (Low) 0.646,3.271 2.615,3.448 1.969,0.177 10 Headlight Unit LH 0.667,3.104 0.958,3.271 0.292,0.167 10 A19 0.458,1.25 0.75,1.417 0.292,0.167 10 E 0.25,1.25 0.542,1.417 0.292,0.167 10 3 6.396,2.26 6.979,2.438 0.583,0.177 10 HRLY 6.135,2.167 6.375,2.344 0.24,0.177 10 15 4.625,1.958 5.208,2.135 0.583,0.177 10 H-LP 5.094,1.563 5.333,1.74 0.24,0.177 10 1 5.094,1.25 5.333,1.427 0.24,0.177 10 5 4.344,1.281 4.583,1.458 0.24,0.177 10 3 4.344,1.531 4.583,1.708 0.24,0.177 10 2 3.052,1.281 3.302,1.458 0.25,0.177 10 2 2.792,1.281 3.083,1.448 0.292,0.167 10 LO 5.406,2.156 5.698,2.323 0.292,0.167 10 37 2.792,4.302 3.083,4.469 0.292,0.167 10 LO 3.052,4.292 3.292,4.469 0.24,0.177 10 2 3.083,4.573 3.927,4.76 0.844,0.188 10 H-LP RH-LO 0.469,4.281 0.76,4.448 0.292,0.167 10 E 0.271,4.281 0.563,4.448 0.292,0.167 10 3 0.75,6.135 1.042,6.302 0.292,0.167 10 A40 0.729,6.302 2.698,6.479 1.969,0.177 10 Headlight Unit RH 5.063,2.906 6.313,3.406 1.25,0.5 10 Instrument Panel Junction Block Assembly 5.063,2.74 5.323,2.906 0.26,0.167 10 3B 5.958,5.156 6.219,5.323 0.26,0.167 10 A 5.958,5.313 7.104,5.844 1.146,0.531 10 Main Body ECU (Multiplex Network Body ECU) 0.115,0.083 1.448,0.281 1.333,0.198 11 for HID Headlight:

E270106E01
4.729,2.656 6.323,3.115 1.594,0.458 10 Instrument Panel Junction Block Assembly 3.052,1.302 3.979,1.5 0.927,0.198 10 H-LP LH-LO 3.094,3.833 4.021,4.031 0.927,0.198 10 H-LP RH-LO 3,0.219 3.896,0.448 0.896,0.229 10 from Battery 0.938,4.344 2.292,4.583 1.354,0.24 10 Headlight Unit RH 0.938,4.198 1.333,4.406 0.396,0.208 10 A39 0.938,1.854 2.292,2.094 1.354,0.24 10 Headlight Unit LH 0.938,1.708 1.333,1.917 0.396,0.208 10 A18 0.979,1.073 1.188,1.281 0.208,0.208 10 E 0.792,1.063 1,1.271 0.208,0.208 10 1 2.104,1.052 2.313,1.26 0.208,0.208 10 LO 2.396,1.063 2.604,1.271 0.208,0.208 10 2 5.167,1.354 5.375,1.563 0.208,0.208 10 1 5.167,1.063 5.375,1.271 0.208,0.208 10 5 4.375,1.063 4.583,1.271 0.208,0.208 10 3 4.719,2.5 5,2.698 0.281,0.198 10 3B 5.458,1.938 5.74,2.135 0.281,0.198 10 37 6.177,1.948 6.458,2.146 0.281,0.198 10 15 6.427,2.052 6.885,2.26 0.458,0.208 10 HRLY 4.958,4.917 5.417,5.198 0.458,0.281 10 A 4.938,5.104 7.115,5.583 2.177,0.479 10 Main Body ECU (Multiplex Network Body ECU) 0.979,3.573 1.188,3.781 0.208,0.208 10 E 2.104,3.583 2.313,3.792 0.208,0.208 10 LO 0.771,3.573 0.979,3.781 0.208,0.208 10 1 4.375,1.344 4.583,1.552 0.208,0.208 10 2 4.635,1.74 5.188,1.938 0.552,0.198 10 H-LP 0.125,0.104 2.094,0.417 1.969,0.313 12 for Halogen Headlight: 2.406,3.573 2.563,3.771 0.156,0.198 10 2

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the bulbs and fuses for circuits related to this system before performing the following inspection procedure.

·

When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (H-LP RELAY)
a.

Using the GTS, perform the Active Test.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Headlight Relay Low beam headlight relay ON or OFF -
Body Electrical > Main Body > Active Test
Tester Display
Headlight Relay
50004 123 14
OK:

Headlight relay operates (low beam headlights come on).



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT HEADLIGHT RELAY (H-LP)
2.INSPECT HEADLIGHT RELAY (H-LP)
a.
E234221N01
2.146,1.771 2.49,1.427 false 2.479,0.719 2.823,0.375 false 3.208,1.083 2.833,1.083 false 2.083,1.083 1.708,1.083 false 0.469,0.719 0.583,0.875 0.115,0.156 10 3 0.469,1.281 0.583,1.438 0.115,0.156 10 2 1.271,0.719 1.385,0.875 0.115,0.156 10 5 1.271,1.281 1.385,1.438 0.115,0.156 10 1 3.229,1.01 3.344,1.167 0.115,0.156 10 5 2.854,0.25 2.969,0.406 0.115,0.156 10 1 1.615,1 1.729,1.156 0.115,0.156 10 3 2.031,1.698 2.146,1.854 0.115,0.156 10 2

Remove the headlight relay from the No. 1 engine room relay block and junction block assembly.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage applied between terminals 1 and 2 Below 1 Ω
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP] - BATTERY)

NG

REPLACE HEADLIGHT RELAY (H-LP)

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP] - BATTERY)
a.

Remove the headlight relay from the No. 1 engine room relay block and junction block assembly.

E272587C01
0.281,0.208 0.594,0.365 0.313,0.156 10 false *A 3.917,0.198 4.229,0.354 0.313,0.156 10 false *B 0.635,0.438 0.948,0.594 0.313,0.156 10 false *a 4.427,0.448 4.74,0.604 0.313,0.156 10 false *a
*A w/o Side Marker Light *B w/ Side Marker Light
*a Front view of wire harness connector
(to Headlight Relay)
- -



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Headlight relay terminal 5 - Body ground Always 11 to 14 V
Headlight relay terminal 1 - Body ground



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP] - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP] - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
a.

Remove the headlight relay from the No. 1 engine room relay block and junction block assembly.


b.

Disconnect the 3B instrument panel junction block assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Headlight relay terminal 2 - 3B-37 Always Below 1 Ω
3B-37 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
a.
E270896N01
1.479,2.281 1.917,2.531 0.438,0.25 0.063,1.01 0.406,1.26 0.344,0.25 1.615,3.042 1.615,2.823 false 0.135,1.052 0.448,1.25 0.313,0.198 10 3B 1.469,3.063 1.906,3.26 0.438,0.198 10 HRLY 1.656,2.323 1.969,2.521 0.313,0.198 10 A

Remove the instrument panel junction block assembly.

for LHD:

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL

for RHD:

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL


b.

Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

for LHD:

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL

for RHD:

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-15 (HRLY) - 3B-37 Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG