Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0047056 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM U

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  FAIL-SAFE CHART  


Automatic Headlight Beam Level Control System


a.

The headlight leveling ECU operates in fail-safe mode if an abnormal condition such as those listed below has been detected.

Item Abnormality Detection Condition Return Condition Warning Light
Height control sensor power source voltage Abnormal height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected. Voltage of 4.61 to 6.24 V is detected Illuminated
Height control sensor signal voltage Abnormal height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected. Voltage of 0.26 to 4.74 V is detected
High power source voltage Abnormal high power source voltage (18.5 V or more) is detected. Voltage of 17.5 V or less is detected Not illuminated
Low power source voltage Abnormal low power source voltage (9.0 V or less) is detected. Voltage of 9.3 V or more is detected Not illuminated
Abnormal height control sensor signal while initialization Initialization is performed outside the valid range of the voltage for initialization. Initialization is successfully completed within the valid range of the voltage for initialization. Illuminated