Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0047056 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM U

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Data List / All Date.


e.

According to the display on the GTS, read the Data List.

Body Electrical > HL AutoLeveling > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Headlight Low Beam State Low beam headlight state ON or OFF ON: Low beam headlights on
OFF: Low beam headlights off
-
+B Ignition power supply voltage value 0 to 19.75 V 11 to 14 V -
Height Sens Pw Supply Val Rear height control sensor power supply value 0 to 5 V Approximately 5.0 V -
Rr Height Sens Signal Val Rear height control sensor signal value 0 to 5 V Approximately 2.5 V (When vehicle level) The value becomes larger when the front of the vehicle tilts up.
Vehicle Speed Vehicle speed 0 to 327.67 km/h Actual vehicle speed -
Rear Height Adjust Valid Flag Result of rear vehicle height calibration Valid or Inval Valid: Rear vehicle height calibration completed
Inval: Rear vehicle height calibration not completed
-
Init Writing Count Number of times initialization performed 0 to 255 Current condition displayed -
Sensor Initialization Hist Sensor initialization history not comp, 10%, 25%, 50%, 75%, 100% or complied Current condition displayed -
Number Of Trouble Codes Number of trouble codes 0 to 255 Condition can be displayed -


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > HL AutoLeveling > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Drive The Leveling Motor Leveling motor Up, Down or Stop -