Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2012.12–2015.04
RM3090E _53 Suspension _008691 TIRE PRESSURE MONITORING _0048202 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  Tire Pressure Warning Light Circuit  


DESCRIPTION

If the tire pressure warning ECU and receiver detects any problems, the tire pressure warning light blinks (stays on after blinking for 1 minute) and tire pressure monitoring is canceled at the same time. At this time, the ECU stores a DTC in memory.

Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink to output DTCs.

The tire pressure warning ECU and receiver sends the tire pressure warning light illumination request signal to the main body ECU (multiplex network body ECU) via a direct line. The main body ECU (multiplex network body ECU) then sends the signal to the combination meter assembly via CAN communication.

WIRING DIAGRAM

C257852
1.365,0.5 1.698,0.708 0.333,0.208 10 G78 1.688,0.49 3.385,0.833 1.698,0.344 10 Main Body ECU (Multiplex Network Body ECU) 3.531,0.75 3.865,0.958 0.333,0.208 10 RDA 3.906,0.646 4.24,0.854 0.333,0.208 10 16 4.906,0.646 5.125,0.875 0.219,0.229 10 4 5.125,0.813 6.542,1.031 1.417,0.219 10 RDA*1, RDA2*2 5.135,1.5 6.51,1.667 1.375,0.167 10 M11*1, M30*2 5.167,1.698 6.927,2.156 1.76,0.458 10 Tire Pressure Warning ECU and Receiver 1.323,1.51 1.656,1.719 0.333,0.208 10 G16 1.792,1.5 3.76,1.677 1.969,0.177 10 Combination Meter Assembly 1.802,1.813 3.771,2 1.969,0.188 10 - Tire Pressure Warning Light 0.542,2.438 2.563,2.615 2.021,0.177 10 : CAN Communication Line 0.073,2.99 2.469,3.208 2.396,0.219 10 *1: for FMVSS138 Type 0.125,3.302 1.729,3.531 1.604,0.229 10 *2: for ECE-R64 Type

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (Click here Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (Click here Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check the CAN communication system.

for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM

for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM

CAN Bus Check
50007
OK:

The CAN communication system is normal.


Result:
Proceed to
OK
NG




OK

2.CHECK DTC OUTPUT (B1247)

NG

2.CHECK DTC OUTPUT (B1247)
a.

Clear the DTCs.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Clear DTCs
50002 123

b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON.


d.

Check for DTCs.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123
OK:

DTC B1247 is not output.


Result:
Proceed to
OK
NG




OK

3.CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)

NG

3.CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


f.

Check the condition of the tire pressure warning light by using the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON -
Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Tire Pressure Warning System
50004 122 57
OK:

The tire pressure warning light turns on or off in accordance with the GTS operation.


Result:
Proceed to
OK
NG




OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG