Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2012.12–2015.04
RM3090E _53 Suspension _008691 TIRE PRESSURE MONITORING _0048202 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2111/11  Transmitter ID1 Operation Stop  C2112/12  Transmitter ID2 Operation Stop  C2113/13  Transmitter ID3 Operation Stop  C2114/14  Transmitter ID4 Operation Stop  C2115/15  Transmitter ID5 Operation Stop  


DESCRIPTION

The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressures. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured air pressure values with the air pressure threshold. When the measured air pressure value is less than this threshold, the warning light in the combination meter assembly illuminates. The tire pressure warning ECU and receiver stores a DTC when the tire pressure warning valve and transmitter stops transmitting signals. The signals can be forcibly transmitted by releasing the tire pressure rapidly. The stored DTC is cleared when signal transmission resumes.

DTC No. Detection Item DTC Detection Condition Trouble Area
C2111/11 Transmitter ID1 Operation Stop The tire pressure warning ECU and receiver receives sleep mode signals from the tire pressure warning valve and transmitters.
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver


C2112/12 Transmitter ID2 Operation Stop The tire pressure warning ECU and receiver receives sleep mode signals from the tire pressure warning valve and transmitters.
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver


C2113/13 Transmitter ID3 Operation Stop The tire pressure warning ECU and receiver receives sleep mode signals from the tire pressure warning valve and transmitters.
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver


C2114/14 Transmitter ID4 Operation Stop The tire pressure warning ECU and receiver receives sleep mode signals from the tire pressure warning valve and transmitters.
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver


C2115/15 Transmitter ID5 Operation Stop The tire pressure warning ECU and receiver receives sleep mode signals from the tire pressure warning valve and transmitters.
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver



C2115/15: w/ Full Size Spare Tire


HINT:

It is necessary to perform the following procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because it cannot be identified by the output DTC.


WIRING DIAGRAM

C257450E03
2.823,0.292 4.844,0.677 2.021,0.385 10 Tire Pressure Warning Valve and Transmitter 2.844,1.583 4.865,1.969 2.021,0.385 10 Tire Pressure Warning Valve and Transmitter 2.833,2.917 4.854,3.302 2.021,0.385 10 Tire Pressure Warning Valve and Transmitter*3 0.313,0.906 2.333,1.292 2.021,0.385 10 Tire Pressure Warning Valve and Transmitter 0.313,2.208 2.333,2.594 2.021,0.385 10 Tire Pressure Warning Valve and Transmitter 2.271,3.958 4.292,4.344 2.021,0.385 10 Main Body ECU (Multiplex Network Body ECU) 4.302,3.885 4.708,4.083 0.406,0.198 10 RDA 4.281,4.323 4.688,4.521 0.406,0.198 10 PRG 4.729,3.76 4.969,3.938 0.24,0.177 10 16 4.771,4.229 5.01,4.406 0.24,0.177 10 4 5.76,3.771 6,3.948 0.24,0.177 10 4 5.698,6.979 5.938,7.156 0.24,0.177 10 12 5.948,3.771 6.615,3.99 0.667,0.219 10 RDA*1, 5.948,3.979 6.615,4.198 0.667,0.219 10 RDA2*2 5.948,4.26 6.615,4.479 0.667,0.219 10 PRG*1, 5.938,4.458 6.604,4.677 0.667,0.219 10 PRG2*2 2.427,4.875 4.344,5.083 1.917,0.208 10 Combination Meter Assembly 2.417,5.188 4.323,5.375 1.906,0.188 10 - Tire Pressure Warning Light 3.052,5.917 3.469,6.073 0.417,0.156 10 DLC3 5.958,6.531 6.625,6.75 0.667,0.219 10 CLSW 5.969,7.24 6.635,7.458 0.667,0.219 10 GND*2 5.76,6.406 6,6.583 0.24,0.177 10 3 5.76,4.198 6,4.375 0.24,0.177 10 5 1.99,7.104 4.271,7.302 2.281,0.198 10 Tire Pressure Warning Reset Switch 2,6.917 2.417,7.073 0.417,0.156 10 G71 3.552,6.427 3.792,6.604 0.24,0.177 10 1 2.406,6.438 2.646,6.615 0.24,0.177 10 2 0.573,7.354 1.531,7.542 0.958,0.188 10 : Radio Waves 0.552,7.729 2.833,7.927 2.281,0.198 10 : CAN Communication Line 0.125,8.073 2.406,8.271 2.281,0.198 10 *1: for FMVSS138 Type 0.135,8.333 2.417,8.531 2.281,0.198 10 *2: for ECE-R64 Type 0.156,8.594 2.438,8.792 2.281,0.198 10 *3: w/ Full Size Spare Tire 5.302,7.854 7.063,8.26 1.76,0.406 10 Tire Pressure Warning ECU and Receiver 5.313,7.677 6.219,7.854 0.906,0.177 10 M11*1, M30*2 6,7.031 6.667,7.25 0.667,0.219 10 E*1, 2.271,3.802 2.729,4 0.458,0.198 10 G78

PROCEDURE

1.PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS
a.

Set the tire pressure to the specified value.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION


b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


g.

Check the values by referring to the table below.

Chassis > Tire Pressure Monitor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ID 1 Tire Inflation Pressure ID1 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*
ID 2 Tire Inflation Pressure ID2 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*
ID 3 Tire Inflation Pressure ID3 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*
ID 4 Tire Inflation Pressure ID4 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*
ID 5 Tire Inflation Pressure ID5 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi)
Actual tire inflation pressure
·

If N/A is displayed, data has not been received.*

·

w/ Full Size Spare Tire


HINT:

*: It may take a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24 (C2125/25: w/ Full Size Spare Tire).

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>C2121/21


Chassis > Tire Pressure Monitor > Data List
Tester Display
ID 1 Tire Inflation Pressure
ID 2 Tire Inflation Pressure
ID 3 Tire Inflation Pressure
ID 4 Tire Inflation Pressure
ID 5 Tire Inflation Pressure
50003 203 36,37,38,39,40

h.

Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.

i.

Check that each tire pressure data displayed on the GTS has changed.

OK:

Each tire pressure data displayed on the GTS will change to the value of the tire pressure.


NOTICE:
·

It may take a few minutes to display the updated tire pressure data.

·

When the "ID Tire Inflation Pressure" data has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the data.




ii.

After confirming that all of the tire pressure data displayed on the GTS has changed, set the tire pressure to the appropriate specified values.

HINT:

If the tire pressure data displayed on the GTS has not changed after rechecking, inspect for another problem.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>C2121/21




Result:
Proceed to
OK
NG



OK

END

NG

GO TO TRANSMITTER AND RECEIVER INSPECTION PROCEDURE