Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › DIESEL THROTTLE BODY
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0048231 DIESEL THROTTLE BODY G

2AD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  INSPECTION  


PROCEDURE

Hide 26100 1.INSPECT DIESEL THROTTLE BODY ASSEMBLY

a.

Check that the there is no sludge accumulating around the diesel throttle body assembly.

NOTICE:

When cleaning the diesel throttle body assembly, use a piece of cloth soaked with cleaning solvent. Spraying the solvent directly onto this part or soaking the part in solvent may damage it.



b.
A214409
2.063,1.615 1.771,0.823 1.771,0.823 1.646,0.823 true 2.271,1.615 2.552,0.844 2.552,0.844 2.688,0.844 true 0.104,0.073 0.417,0.229 0.313,0.156 10 *a 1.365,0.75 1.677,0.948 0.313,0.198 10 M+ 2.792,0.76 3.104,0.958 0.313,0.198 10 M-
*a Component without harness connected (Diesel Throttle Body Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω


NOTICE:

Be sure to move the throttle valve when measuring the resistance.


If the result is not as specified, replace the diesel throttle body assembly.