Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › MASS AIR FLOW METER
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0048232 MASS AIR FLOW METER G

2AD-FTV ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter sub-assembly inspection according to the procedures below.

·

Only replace the mass air flow meter sub-assembly when the mass air flow value in the Data List (with the engine stopped) is not within the normal operating range.



PROCEDURE

Hide 22204 1.CHECK MASS AIR FLOW METER SUB-ASSEMBLY

a.

Check the mass air flow value.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

Powertrain > Engine > Data List
Tester Display
MAF
50003 61 319

v.
A204312

Blow air into the mass air flow meter sub-assembly, and check that the mass air flow value fluctuates.

·

for CCo:

If the result is not as specified, check the mass air flow meter sub-assembly, or wiring and ECM.

Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>P0100

·

for DPF:

If the result is not as specified, check the mass air flow meter sub-assembly, or wiring and ECM.

Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>P0100