Home › Engine / Hybrid System › 2AD-FHV INTAKE / EXHAUST › EXHAUST MANIFOLD W/ TURBOCHARGER
RM3090E _51 Engine / Hybrid System _008382 2AD-FHV INTAKE / EXHAUST _0048455 EXHAUST MANIFOLD W/ TURBOCHARGER G

2AD-FHV INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER  INSPECTION  


PROCEDURE

Hide 17201 1.VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY

a.

Check for deformation and cracks in the turbine wheel on the exhaust side.

A227549
2.063,2.448 2.771,0.656 2.771,0.656 3.021,0.656 true 0.5,2.417 1.833,2.417 true 0.354,2.323 0.667,2.479 0.313,0.156 10 false *1 3.063,0.583 3.219,0.781 0.156,0.198 10 false A
*1 Turbine Wheel - -


If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.

HINT:

The cut part indicated in the illustration at A is normal and does not indicate that the turbine wheel is damaged.



Hide 17201 2.CHECK TURBINE SHAFT ROTATION

a.
A227565

Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly.

If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.

HINT:

Due to the viscosity of the oil, it may take a little effort to rotate the turbine wheel. This is not a problem.



b.
A227564

Move the turbine wheel as shown in the illustration and check that there is no looseness in the shaft and that the turbine wheel does not contact the housing.

If there is any contact with the housing or obvious looseness in the shaft, replace the turbocharger sub-assembly.

HINT:

A clearance on the order of 100 μm exists between the turbine shaft and bearings. If it is difficult to judge the looseness of the turbine shaft, perform the same inspection on another vehicle which has the same turbocharger sub-assembly and compare the clearance.