Home › Drivetrain › EA64 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE UNIT
RM3090E _52 Drivetrain _008755 EA64 MANUAL TRANSMISSION / TRANSAXLE _0048555 MANUAL TRANSAXLE UNIT G

EA64 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE UNIT  INSPECTION  


PROCEDURE

Hide 33461 1.INSPECT REVERSE IDLER GEAR THRUST CLEARANCE

a.
C113642

Using a feeler gauge, measure the reverse idler gear thrust clearance.

Standard clearance:

0.40 to 1.05 mm (0.0158 to 0.0413 in.)


Maximum clearance:

1.05 mm (0.0413 in.)


If the clearance is more than the maximum, replace the reverse idler gear, needle roller bearing and reverse idler gear shaft.


Hide 33461 2.INSPECT REVERSE IDLER GEAR RADIAL CLEARANCE

a.
C113646

Using a dial indicator, measure the reverse idler gear radial clearance.

Standard clearance:

0.015 to 0.048 mm (0.000591 to 0.00188 in.)


Maximum clearance:

0.048 mm (0.00188 in.)


If the clearance is more than the maximum, replace the reverse idler gear, needle roller bearing and reverse idler gear shaft.