Home › Drivetrain › EA64 MANUAL TRANSMISSION / TRANSAXLE › INPUT SHAFT
RM3090E _52 Drivetrain _008755 EA64 MANUAL TRANSMISSION / TRANSAXLE _0048556 INPUT SHAFT G

EA64 MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  INSPECTION  


PROCEDURE

Hide 33311 1.INSPECT INPUT SHAFT

a.
C113554

Check the input shaft for wear and damage.


b.

Using a dial indicator, measure the input shaft runout.

Maximum runout:

0.03 mm (0.00118 in.)


If the runout is more than the maximum, replace the input shaft.


c.
C112446
1.435,0.969 1.435,0.72 false 3.224,0.973 3.224,0.724 false 1.378,0.523 1.515,0.693 0.137,0.17 10 A 3.175,0.518 3.313,0.688 0.137,0.17 10 B

Using a micrometer, measure the journal diameter at A and B on the input shaft.

Standard Journal Diameter:
Measured Part Specified Condition
Journal A 30.008 to 30.020 mm (1.1815 to 1.1818 in.)
Journal B 32.002 to 32.018 mm (1.2600 to 1.2605 in.)


If the diameter is not as specified, replace the input shaft.