Home › Drivetrain › EA64 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE › 2012.12–2013.11
RM3090E _52 Drivetrain _008755 EA64 MANUAL TRANSMISSION / TRANSAXLE _0048559 DIFFERENTIAL CASE A

EA64 MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  REASSEMBLY  


PROCEDURE

Hide 41331F 1.INSTALL FRONT DIFFERENTIAL SIDE GEAR

a.
C117507

Coat the rotating surface of the front differential side gear with gear oil.


b.

Install the 2 front differential side gears and 2 front differential side gear thrust washers to the front differential case.


Hide 41341F 2.INSTALL FRONT DIFFERENTIAL PINION

a.
C083566

Coat the rotating surface of the front differential pinion with gear oil.


b.

Install the 2 front differential pinion thrust washers and 2 front differential pinions to the front differential case.

HINT:

Install the 2 front differential pinions with the front differential washers while turning the front differential pinion.



c.
C117493

Install the No. 1 front differential pinion shaft into the front differential case.


d.
C117494

Using a 5 mm pin punch and hammer, install the front differential pinion shaft straight pin through the front differential case and the hole in the No. 1 front differential pinion shaft.


e.
C117495

Using a hammer and chisel, caulk the pin holes around the circumference of the front differential case.


Hide 41221 3.INSTALL FRONT DIFFERENTIAL RING GEAR

a.

Clean the contact surfaces of the front differential case and front differential ring gear.


b.

Heat the front differential ring gear to 90 to 110°C (194 to 230°F) in boiling water.


c.
C117489
1.677,1.5 0.594,0.354 0.594,0.354 1.677,1.396 false 0.396,0.229 0.781,0.417 0.385,0.188 10 *a
*a Matchmark


After the moisture on the ring gear has completely evaporated, quickly align the matchmarks on the front differential ring gear and the front differential case and install the front differential ring gear to the front differential case.


d.

Install the 16 bolts.

Torque:
106 N*m (1081 kgf*cm, 78 ft.*lbf)


Hide 41311E 4.INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING

a.
C117497
2.406,0.292 1.979,0.292 false 2.5,0.219 2.802,0.552 0.302,0.333 10 SST

Using SST and a press, press in a new front differerntial case front tapered roller bearing.

SST
09308-14010  


Hide 41311F 5.INSTALL FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING

a.
C133923C01
1.531,0.854 1.219,0.438 1.219,0.438 1.042,0.438 false 1.938,0.063 2.323,0.063 false 0.729,0.354 1.063,0.521 0.333,0.167 10 SST 2.375,0 2.688,0.188 0.313,0.188 10 *a
*a Press


Using SST and a press, press in a new rear tapered roller bearing.

SST
09554-22010