Home › Drivetrain › EB61 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE › 2012.12–2013.11
RM3090E _52 Drivetrain _008757 EB61 MANUAL TRANSMISSION / TRANSAXLE _0048571 DIFFERENTIAL CASE G

EB61 MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

a.
C200234

Using a dial indicator, measure the front differential side gear backlash.

Standard backlash:

0.05 to 0.20 mm (0.00197 to 0.00787 in.)


If the backlash is not as specified, replace the front No. 1 differential side gear thrust washers with washers of a different thickness. Use the table below to select a front No. 1 differential side gear thrust washer which will ensure that the backlash is within the specification.

Standard Thrust Washer Thickness:
Mark Specified Condition
1 1.00 mm (0.0394 in.)
2 1.10 mm (0.0433 in.)
3 1.20 mm (0.0472 in.)
4 1.30 mm (0.0511 in.)


HINT:

Select washers of the same thickness for both the right and left sides.



Hide 41351F 2.INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER

a.
C193762

Using a micrometer, measure the thickness of the front differential pinion thrust washer.

Minimum thickness:

0.9 mm (0.0354 in.)


If the thickness is less than the minimum, replace the front differential pinion thrust washer.


Hide 41342F 3.INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT

a.
C199374

Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.

Minimum outer diameter:

17.975 mm (0.708 in.)


If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.