Home › Drivetrain › EB61F MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE › 2012.12–2014.10
RM3090E _52 Drivetrain _008758 EB61F MANUAL TRANSMISSION / TRANSAXLE _0048577 DIFFERENTIAL CASE A

EB61F MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  REASSEMBLY  


PROCEDURE

Hide 41331F 1.INSTALL FRONT DIFFERENTIAL SIDE GEAR

a.

Coat the contact surfaces of the front differential side gears with gear oil.


b.

Install the 2 front No. 1 differential side gear thrust washers to the 2 front differential side gears.


c.
C207069

Install the 2 front differential side gears, 2 front differential pinions, and 2 front differential pinion thrust washers to the front differential case.

HINT:

While rotating the front differential side gears, install the 2 front differential pinions and 2 front differential pinion thrust washers.



Hide 41342F 2.INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT

a.

Coat the front No. 1 differential pinion shaft with MP grease.


b.
C207066

Install the front No. 1 differential pinion shaft to the front differential case so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case.


Hide 3.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

Hide 41342A 4.INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

a.
C207070

Using a 5 mm pin punch and hammer, tap in the front differential pinion shaft straight pin to the front differential case.


b.
C200238

Using a chisel and hammer, stake the front differential case.


Hide 41221 5.INSTALL FRONT DIFFERENTIAL RING GEAR

a.

Clean the contact surfaces of the front differential case and front differential ring gear.


b.

Heat the front differential ring gear to 90 to 110°C (194 to 230°F) in boiling water.


c.
C207064C02
1.99,0.49 1.208,0.167 false 1.208,0.167 0.5,0.167 false 1.927,0.667 1.208,0.167 false 0.26,0.083 0.51,0.271 0.25,0.188 10 *a
*a Matchmark


After the moisture on the front differential ring gear has completely evaporated, quickly align the matchmarks on the front differential ring gear and the front differential case and install the front differential ring gear to the front differential case.


d.

Install the 12 bolts.

Torque:
106 N*m (1081 kgf*cm, 78 ft.*lbf)


Hide 41311R 6.INSTALL FRONT DIFFERENTIAL CASE OIL SEAL

a.
C204253C01
0.458,1.385 0.698,1.385 false 2.594,0.938 2.865,0.938 false 2.573,1.031 2.75,1.031 false 2.75,1.031 2.75,0.938 false 0.073,1.302 0.375,1.448 0.302,0.146 10 SST 2.885,0.854 3.188,1 0.302,0.146 10 SST 1.573,0.875 1.833,1.104 0.26,0.229 10 *a
*a Depth


Using SST and a hammer, tap in a new front differential case oil seal to the front differential case.

SST
09950-60010  (09951-00330, 09951-00410, 09952-06010)
09950-70010  (09951-07100)

Standard depth:

21.5 to 22.5 mm (0.847 to 0.885 in.)