*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the display indicates a communication fault with the GTS, inspect the DLC3.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs (Click here Engine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DTC CHECK / CLEAR) and freeze frame data (Click here Engine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>FREEZE FRAME DATA).
Record or print DTCs and freeze frame data if necessary.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs and freeze frame data (Click here Engine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>FREEZE FRAME DATA).
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Confirm problem symptoms.
If the engine does not start, first perform the "Check DTC" and "Conduct Basic Inspection" procedures below.
| Proceed to |
|---|
| Malfunction occur |
| Malfunction does not occur |
Malfunction occur
Malfunction does not occur
Check for DTCs.
| Proceed to |
|---|
| DTC is output |
| DTC is not output |
DTC is output
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DIAGNOSTIC TROUBLE CODE CHART
DTC is not output
Conduct basic inspection (Click here Engine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>BASIC INSPECTION).
Refer to Basic Inspection.
| Proceed to |
|---|
| Malfunctioning parts not confirmed |
| Malfunctioning parts confirmed |
Malfunctioning parts not confirmed
Malfunctioning parts confirmed
Refer to Problem Symptoms Table (Click here Engine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>PROBLEM SYMPTOMS TABLE).
Also, refer to the inspection procedure for the problem symptom.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT