Home › Engine / Hybrid System › 3ZR-FAE ENGINE CONTROL › SFI SYSTEM › 2012.12–2015.04
RM3090E _51 Engine / Hybrid System _008381 3ZR-FAE ENGINE CONTROL _0048627 SFI SYSTEM L

3ZR-FAE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System (Refer to the Service Bulletin for Registration).

·

Make sure to perform Reset Memory (CVT initialization) deceleration sensor zero point calibration and CVT oil pressure calibration when replacing the ECM (Click here Drivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION).




WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One drives the vehicle and the other operates the GTS.



IGNITION SWITCH EXPRESSIONS


HINT:

The type of ignition switch used on this model differs depending on the specifications of the vehicle.

The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition switch off LOCK Off (Lock)
Ignition switch ACC ACC On (ACC)
Ignition switch ON ON On (IG)
Engine Start START On (Start)