*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the display indicates a communication fault in the GTS, inspect the DLC3.
When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR) and freeze frame data (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>FREEZE FRAME DATA).
Record or print DTCs and freeze frame data, if necessary.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs and freeze frame data (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Switch the ECM from normal mode to check mode.
Refer to Check Mode Procedure (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>CHECK MODE PROCEDURE).
| Proceed to |
|---|
| NEXT |
NEXT
Confirm problem symptoms.
If the engine does not start, first perform the "Check DTC" procedure and "Conduct Basic Inspection" procedure below.
| Result | Proceed to |
|---|---|
| Malfunction does not occur | A |
| Malfunction occurs | B |
A
B
Refer to Symptom Simulation (Click here General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Refer to DTC Check / Clear (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
Refer to Diagnostic Trouble Code Chart (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
| Proceed to |
|---|
| NEXT |
NEXT
Conduct basic inspection.
Refer to Basic Inspection (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>BASIC INSPECTION).
| Result | Proceed to |
|---|---|
| Malfunctioning parts not confirmed | A |
| Malfunctioning parts confirmed | B |
A
B
Refer to Problem Symptoms Table (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>PROBLEM SYMPTOMS TABLE).
| Result | Proceed to |
|---|---|
| Malfunctioning circuit confirmed | A |
| Malfunctioning parts confirmed | B |
A
B
Check the ECM power source circuit.
Refer to ECM Power Source Circuit (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>ECM Power Source Circuit).
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Malfunction not confirmed | A |
| Malfunction confirmed | B |
A
B
Check for intermittent problems.
Refer to Check for Intermittent Problems (Click here Engine / Hybrid System>3ZR-FAE ENGINE CONTROL>SFI SYSTEM>CHECK FOR INTERMITTENT PROBLEMS).
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT