Home › Engine / Hybrid System › 2AD-FTV EMISSION CONTROL › EXHAUST FUEL ADDITION INJECTOR(for DPF)
RM3090E _51 Engine / Hybrid System _008737 2AD-FTV EMISSION CONTROL _0048712 EXHAUST FUEL ADDITION INJECTOR(for DPF) G

2AD-FTV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR(for DPF)  INSPECTION  


PROCEDURE

Hide 23710B 1.INSPECT EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 7.1 to 7.9 Ω


HINT:

The temperature indicated in "Condition" is the temperature of the exhaust fuel addition injector assembly.


If the result is not as specified, replace the exhaust fuel addition injector assembly.