Home › Engine / Hybrid System › 2AD-FTV EMISSION CONTROL › VACUUM REGULATING VALVE
RM3090E _51 Engine / Hybrid System _008737 2AD-FTV EMISSION CONTROL _0048714 VACUUM REGULATING VALVE G

2AD-FTV EMISSION CONTROL  VACUUM REGULATING VALVE  INSPECTION  


PROCEDURE

Hide 25819 1.INSPECT VACUUM REGULATING VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 11.1 to 12.5 Ω


If the result is not as specified, replace the vacuum regulating valve assembly.


b.

Inspect vacuum regulating valve operation.

i.
A201833
0.625,1.844 0.844,1.844 0.844,1.844 1.073,1.594 false 1.323,1.635 1.573,1.833 1.573,1.833 1.771,1.833 true 1.823,1.729 1.979,1.927 0.156,0.198 10 E 0.469,1.74 0.625,1.938 0.156,0.198 10 G
V100135

Air


Check that air flows from port E to G.


ii.
A201834
1.281,0.448 1.49,0.448 1.49,0.448 1.625,1 false 1.417,1.552 1.719,1.74 1.719,1.74 1.885,1.74 true 2.073,0.375 2.281,0.375 2.281,0.375 2.177,0.969 false 2.271,1.063 2.479,1.156 2.479,1.156 2.667,1.156 true 1.948,1.615 2.104,1.813 0.156,0.198 10 E 1.063,0.323 1.375,0.479 0.313,0.156 10 *1 2.708,1.031 2.865,1.229 0.156,0.198 10 1 1.958,0.24 2.115,0.438 0.156,0.198 10 2
*1 Filter
V100135

Air


Apply battery voltage across terminals 1 and 2 as shown in the illustration.


iii.

Check that air flows from port E to the filter.

If the result is not as specified, replace the vacuum regulating valve assembly.