Home › Drivetrain › GF1A TRANSFER / 4WD / AWD › DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM › 2012.12–2015.10
RM3090E _52 Drivetrain _008760 GF1A TRANSFER / 4WD / AWD _0048749 DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM U

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM  FAIL-SAFE CHART  


FAIL-SAFE FUNCTION


·

If the following malfunctions occur, the 4WD ECU assembly will stop the function of the dynamic torque control 4WD/AWD system or partly change the function to control the system.

·

If a malfunction occurs in the sensor signal or actuator, the flow of electricity to the 4WD linear solenoid of the transmission coupling assembly is prohibited. As a result, the system enters front wheel drive condition.

·

When a component of the system malfunctions and the fail-safe function activates, the component operation is prohibited. However, if the system is controlling the component and the fail-safe function activates, the system operation is gradually stopped to prevent sudden changes in the vehicle condition.

·

for Segment Display Type:

When system control is not possible, the 4WD/AWD warning light is illuminated to stop system operation.

for Dot Display Type:

When system control is not possible, a warning message is displayed to stop system operation.