Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2012.12–2015.10
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0048751 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  Slip Indicator Light does not Come ON  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Result:
Proceed to
DTC is not output
DTC is output (for LHD)
DTC is output (for RHD)



DTC is not output

2.CHECK SLIP INDICATOR LIGHT

DTC is output (for LHD)

DTC is output (for RHD)

2.CHECK SLIP INDICATOR LIGHT
a.

Disconnect the A64 skid control ECU (brake actuator assembly) connector.


b.

Turn the ignition switch to ON.


c.

Check that the slip indicator light comes on.

OK:

The slip indicator light comes on.



Result:
Proceed to
OK
NG



OK

NG

3.PERFORM ACTIVE TEST USING GTS (SLIP INDICATOR LIGHT)
3.PERFORM ACTIVE TEST USING GTS (SLIP INDICATOR LIGHT)
a.

Turn the ignition switch off.


b.

Reconnect the A64 skid control ECU (brake actuator assembly) connector.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


g.

According to the display on the GTS, perform the Active Test.


Chassis > ABS/VSC/TRC > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Slip Indicator Light Slip indicator light Indicator light OFF/ON Observe combination meter
Vehicle condition: Vehicle stopped
h.

When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.


Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Slip Indicator Light Slip indicator light OFF or ON OFF: Indicator light off
ON: Indicator light on
-
Chassis > ABS/VSC/TRC > Active Test
Active Test Display
Slip Indicator Light
Data List Display
Slip Indicator Light
50004 105 11 304
Result:
Result Proceed to
Slip indicator light in the Data List does not change using the Active Test A
Slip indicator light in the Data List turns ON/OFF using the Active Test B



A

B

4.INSPECT COMBINATION METER ASSEMBLY
4.INSPECT COMBINATION METER ASSEMBLY
a.

Turn the ignition switch off.


b.

Perform Active Test of the combination meter assembly using the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp Slip
50004 122 16

c.

Check the combination meter assembly.


OK:

The slip indicator light turns on or off in accordance with the GTS.


Result:
Proceed to
OK
NG



OK

NG