These solenoids turn on when signals are received from the skid control ECU (brake actuator assembly) and they control the pressure acting on the wheel cylinders to control the braking force.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1225 | SM Solenoid Circuit | When any of the following is detected:
1.
While outputting switching solenoid (SM1 or SM2) ON, overcurrent continues for 0.1 seconds or more. 2.
While outputting switching solenoid (SM1 or SM2) OFF, an open circuit continues for 0.05 seconds or more. 3.
While outputting switching solenoid (SM1 or SM2) ON, an open circuit continues for 0.05 seconds or more. 4.
While outputting switching solenoid (SM1 or SM2) OFF, current continues to be applied for 0.05 seconds or more. 5.
A condition in which the outputs from switching solenoids 1 and 2 are different continues for 0.2 seconds or more. |
Brake actuator assembly |
| C1468 | SFR Solenoid Circuit | Open or short in the solenoid circuit continues for 0.05 seconds or more. | Brake actuator assembly |
| C1469 | SFL Solenoid Circuit | Open or short in the solenoid circuit continues for 0.05 seconds or more. | Brake actuator assembly |
| C146A | SRR Solenoid Circuit | Open or short in the solenoid circuit continues for 0.05 seconds or more. | Brake actuator assembly |
| C146B | SRL Solenoid Circuit | Open or short in the solenoid circuit continues for 0.05 seconds or more. | Brake actuator assembly |
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
These codes are detected when a problem is determined in the skid control ECU (brake actuator assembly).
The solenoid circuits are in the skid control ECU (brake actuator assembly).
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTCs are output before replacing the skid control ECU (brake actuator assembly).
Clear the DTC.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC is not output |
| DTC is output |
If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU (brake actuator assembly), with the ignition switch ON and the stop light switch off, the ECU performs self diagnosis of the motor and solenoid circuits.
If the normal system code is output (the trouble code is not output), slightly jiggle the connectors, wire harness, and fuses of the skid control ECU (brake actuator assembly). Make sure that no DTCs are output.
If any DTCs are output while jiggling a connector or wire harness from the skid control ECU (brake actuator assembly), inspect and repair the connector or wire harness.
The DTCs were probably output due to a bad connection of the connector terminal.
DTC is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC is output