Home › Engine / Hybrid System › 2AD-FHV ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM3090E _51 Engine / Hybrid System _008730 2AD-FHV ENGINE CONTROL _0048776 CAMSHAFT POSITION SENSOR A

2AD-FHV ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:
·

When reusing the camshaft position sensor, inspect the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.




b.

Install the camshaft position sensor with the bolt.

Torque:
8.8 N*m (90 kgf*cm, 78 in.*lbf)


c.

Connect the camshaft position sensor connector.