Home › Engine / Hybrid System › 1AD-FTV ENGINE CONTROL › INTAKE AIR TEMPERATURE SENSOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008729 1AD-FTV ENGINE CONTROL _0048790 INTAKE AIR TEMPERATURE SENSOR A

1AD-FTV ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89424D 1.INSTALL INTAKE AIR TEMPERATURE SENSOR

a.

Install a new gasket to the intake air temperature sensor.


b.

Using a 22 mm ball joint lock nut wrench, install the intake air temperature sensor.

Torque:
34.3 N*m (350 kgf*cm, 25 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



c.

Connect the intake air temperature sensor connector.


Hide 51441 2.INSTALL NO. 1 ENGINE UNDER COVER