Home › Engine / Hybrid System › 1AD-FTV ENGINE CONTROL › AIR FUEL RATIO SENSOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008729 1AD-FTV ENGINE CONTROL _0048792 AIR FUEL RATIO SENSOR A

1AD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

a.
A273330C01
0.833,1.188 0.573,0.708 0.573,0.708 0.406,0.708 false 2.292,0.406 2.604,0.563 0.313,0.156 10 false *1 0.073,0.635 0.531,0.833 0.458,0.198 10 false SST
*1 Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with afulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Make sure SST and the wrench are connected in a straight line.




b.

Install the harness clamp.


Hide 2.INSTALL FRONT EXHAUST PIPE ASSEMBLY