The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
Disconnect the G150 radio and display receiver assembly connector.
Disconnect the G145 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G150-2 (UDO-) - G145-2 (UDO-) | Always | Below 1 Ω |
| G150-3 (UDO+) - G145-3 (UDO+) | Always | Below 1 Ω |
| G150-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| G150-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG