These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Sending Malfunction (Navigation to APGS) | CAN bus connection error | CAN communication system |
| U0100 | Lost Communication with ECM / PCM "A" | CAN reception error | CAN communication system |
| U0126 | Lost Communication with Steering Angle Sensor Module | CAN reception error | CAN communication system |
| U0129 | Lost Communication with Brake System Control Module | CAN reception error | CAN communication system |
| U0131 | Lost Communication with Electric Power Steering ECU | CAN reception error | CAN communication system |
| U0140 | Lost Communication with Body Control Module | CAN reception error | CAN communication system |
| U0155 | Meter ECU Communication | CAN reception error | CAN communication system |
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
| Proceed to |
|---|
| No DTCs are output |
| CAN DTCs are output (for LHD) |
| CAN DTCs are output (for RHD) |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
CAN DTCs are output (for LHD)
CAN DTCs are output (for RHD)