Home › Drivetrain › U660F AUTOMATIC TRANSMISSION / TRANSAXLE › ATF TEMPERATURE SENSOR
RM3090E _52 Drivetrain _008436 U660F AUTOMATIC TRANSMISSION / TRANSAXLE _0047083 ATF TEMPERATURE SENSOR G

U660F AUTOMATIC TRANSMISSION / TRANSAXLE  ATF TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT ATF TEMPERATURE SENSOR ASSEMBLY

a.

Disconnect the ATF temperature sensor connector.


b.
C206308
2.26,1.438 2.042,1.063 true 1.688,1.438 1.875,1.063 true 1.563,1.479 1.802,1.677 0.24,0.198 10 E2 2.115,1.479 2.542,1.677 0.427,0.198 10 THO1 0.677,0.427 0.99,0.625 0.313,0.198 10 *a
*a Component without TCM connected
(ATF Temperature Sensor Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
THO1 - E2 Always 79 Ω to 156 kΩ
THO1 - Body ground Always 10 kΩ or higher
E2 - Body ground Always 10 kΩ or higher


HINT:

If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.


Resistance (Reference):
ATF Temperature Specified Condition
10°C (50°F) 5 to 8 kΩ
25°C (77°F) 2.5 to 4.5 kΩ
110°C (230°F) 0.22 to 0.28 kΩ


Result:
Proceed to
OK
NG


If the result is not as specified, replace the ATF temperature sensor assembly.