Home › Drivetrain › U660F AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY
RM3090E _52 Drivetrain _008436 U660F AUTOMATIC TRANSMISSION / TRANSAXLE _0047085 VALVE BODY ASSEMBLY A

U660F AUTOMATIC TRANSMISSION / TRANSAXLE  VALVE BODY ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 35418 1.INSTALL MANUAL VALVE

a.

Coat the manual valve with ATF and install it to the transmission valve body assembly.


Hide 35410 2.INSTALL TRANSMISSION VALVE BODY ASSEMBLY

a.

Coat the O-ring of the transmission wire with ATF.


b.
C136689C01
2.01,2.188 1.438,2.865 1.438,2.865 0.875,2.344 false 1.635,2.188 1.438,2.854 1.438,2.854 1.208,2.219 false 2.083,0.948 2.479,0.208 2.479,0.208 2.552,0.208 false 1.344,0.938 1.708,0.229 1.708,0.229 1.771,0.229 false 0.896,0.896 1.167,0.24 1.167,0.24 1.229,0.24 false 0.5,1.344 0.24,0.969 false 0.479,2.042 0.271,2.385 false 2.313,2.188 2.688,2.75 2.688,2.75 2.771,2.75 false 2.75,1.594 2.865,2.021 2.865,2.021 2.948,2.021 false 0.125,2.563 0.396,2.74 0.271,0.177 10 (*a) 2.604,0.125 2.75,0.281 0.146,0.156 10 A 1.406,2.885 1.552,3.042 0.146,0.156 10 B 0.125,0.833 0.271,0.99 0.146,0.156 10 D 1.281,0.167 1.427,0.323 0.146,0.156 10 C 0.177,2.396 0.323,2.552 0.146,0.156 10 E 2.99,1.948 3.135,2.104 0.146,0.156 10 B 1.813,0.156 1.958,0.313 0.146,0.156 10 B 3.135,1.927 3.385,2.104 0.25,0.177 10 (*a) 2.823,2.677 2.969,2.833 0.146,0.156 10 B
*a Positioning Bolt


Confirm that the manual valve lever is positioned as shown in the illustration and install the transmission valve body assembly to the transaxle case with the 11 bolts.

Torque:
10.8 N*m (110 kgf*cm, 8 ft.*lbf)

NOTICE:
·

When installing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and transaxle case to interfere with each other.

·

Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.

·

First, temporarily install the bolts marked (*a) in the illustration because they are positioning bolts.



HINT:

Bolt length:

Bolt A: 25 mm (0.984 in.)

Bolt B: 30 mm (1.18 in.)

Bolt C: 35 mm (1.38 in.)

Bolt D: 45 mm (1.77 in.)

Bolt E: 55 mm (2.17 in.)



Hide 35330 3.INSTALL VALVE BODY OIL STRAINER ASSEMBLY

a.

Coat a new O-ring with ATF and install it to the valve body oil strainer assembly.

NOTICE:

Ensure that the O-ring is not twisted or pinched.



b.

Install the valve body oil strainer assembly to the transmission valve body assembly with the 2 bolts.

Torque:
10.8 N*m (110 kgf*cm, 8 ft.*lbf)


Hide 35106D 4.INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

a.
C134963C02
2.885,0.198 1.865,0.198 1.865,0.198 1.865,1.427 false 2.427,0.99 2.427,0.208 false 2.958,0.125 3.125,0.292 0.167,0.167 10 *1
*1 Transmission Oil Cleaner Magnet


Install the 2 transmission oil cleaner magnets onto the automatic transaxle oil pan sub-assembly as shown in the illustration.


b.

Install a new gasket to the automatic transaxle oil pan sub-assembly.


c.
C279450

Install the automatic transaxle oil pan sub-assembly to the automatic transaxle assembly with the 17 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


d.
C279451

Clean and degrease the bolt and the installation hole in the automatic transaxle assembly.


e.

Apply adhesive to the bolt.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



f.

Install the bolt.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)

NOTICE:
·

In order to ensure proper sealing of the transmission oil pan bolts, apply adhesive to the bolts and install them within 10 minutes of adhesive application.

·

Completely remove any oil or grease from the contact surface of the transaxle case and automatic transaxle oil pan sub-assembly with the gasket before installation.




Hide 51218A 5.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH

a.
C206484

Install the front suspension member reinforcement LH with the 4 bolts.

Torque:
99 N*m (1010 kgf*cm, 73 ft.*lbf)


Hide 51444 8.INSTALL REAR ENGINE UNDER COVER LH

Hide 51441 9.INSTALL NO. 1 ENGINE UNDER COVER

Hide 10.RESET MEMORY

NOTICE:

If automatic transaxle parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.

Click hereDrivetrain>U660F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION