Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0049188 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when the ignition switch is off. The power is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E269935E03
3.281,0.729 4.198,0.927 0.917,0.198 10 false ECU-B NO.2 1.177,0.542 2.042,0.771 0.865,0.229 10 false from Battery 5.771,0.563 6.115,0.75 0.344,0.188 10 false B 5.531,0.448 5.74,0.615 0.208,0.167 10 false 21 5.521,1.156 5.74,1.344 0.219,0.188 10 false 14 5.771,1.281 6.167,1.469 0.396,0.188 10 false GND 5.438,1.802 5.833,1.99 0.396,0.188 10 false G81 5.438,1.979 7.021,2.417 1.583,0.438 10 false Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BATTERY)
a.
E269948C04
1.5,0.313 1.927,0.552 0.427,0.24 3,1.656 2.823,1.656 2.823,1.656 2.667,1.417 true 0.042,0.052 0.354,0.25 0.313,0.198 10 *a 1.583,0.354 1.896,0.552 0.313,0.198 10 G81 3.052,1.573 3.26,1.76 0.208,0.188 10 B
*a Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G81-21 (B) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.
E269948C05
1.5,0.313 1.927,0.552 0.427,0.24 0.583,0.865 0.802,0.865 0.802,0.865 1.365,1.271 true 0.042,0.052 0.354,0.25 0.313,0.198 10 *a 1.583,0.354 1.896,0.552 0.313,0.198 10 G81 0.188,0.781 0.573,0.969 0.385,0.188 10 GND
*a Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G81-14 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR