Home › Engine / Hybrid System › 1AD-FTV ENGINE MECHANICAL › CYLINDER HEAD › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008733 1AD-FTV ENGINE MECHANICAL _0049236 CYLINDER HEAD A

1AD-FTV ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR INTAKE VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Take off the cutter gradually to make the valve seat smooth.



a.
A110502
2.302,0.406 2.594,0.604 0.292,0.198 10 45° 3.156,0.552 3.427,0.75 0.271,0.198 10 30° 2.438,1.844 2.75,2 0.313,0.156 10 *1
*1 Width


If the seating is too high on the valve face, use 30° and 45° cutters to correct the intake valve seat.


b.
A101380
2.25,0.438 2.542,0.635 0.292,0.198 10 60° 3.083,0.604 3.365,0.802 0.281,0.198 10 45° 2.406,1.979 2.719,2.135 0.313,0.156 10 *1
*1 Width


If the seating is too low on the valve face, use 60° and 45° cutters to correct the intake valve seat.


c.

Check that the seat contact is in the middle of the valve face and has the following width.

Standard width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



Hide 2.REPAIR EXHAUST VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Take off the cutter gradually to make the valve seat smooth.



a.
A110503
2.417,0.281 2.688,0.448 0.271,0.167 10 45° 3.156,0.563 3.427,0.729 0.271,0.167 10 30° 2.427,1.844 2.74,2 0.313,0.156 10 *1
*1 Width


If the seating is too high on the valve face, use 30° and 45° cutters to correct the exhaust valve seat.


b.
A101382
2.26,0.333 2.51,0.5 0.25,0.167 10 60° 3.115,0.542 3.396,0.708 0.281,0.167 10 45° 2.438,1.958 2.75,2.115 0.313,0.156 10 *1
*1 Width


If the seating is too low on the valve face, use 60° and 45° cutters to correct the exhaust valve seat.


c.

Check that the seat contact is in the middle of the valve face and has the following width.

Standard width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)