Home › Engine / Hybrid System › 1AD-FTV FUEL › FUEL FILTER › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008413 1AD-FTV FUEL _0049270 FUEL FILTER A

1AD-FTV FUEL  FUEL FILTER  REPLACEMENT  


PROCEDURE

Hide 17705 2.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 3.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 5.REMOVE FUEL FILTER ASSEMBLY

a.

Disconnect the level warning switch connector.


b.

Slide the 4 clamps and disconnect the fuel hose, No. 1 fuel hose, No. 2 fuel hose and No. 3 fuel hose from the fuel filter assembly.


c.

Remove the bolt and fuel filter assembly.

A271453


Hide 6.DRAIN FUEL

a.
A131639

Loosen the drain plug and drain the fuel from the fuel filter assembly.


Hide 23390 8.REMOVE FUEL FILTER ELEMENT ASSEMBLY

a.
A131641E02
0.824,0.294 1.147,0.478 0.323,0.184 10 SST 2.337,0.934 1.757,0.378 false 1.759,0.374 1.197,0.374 false

Using SST, remove the fuel filter element assembly.

SST
09228-64030  


Hide 23390 9.INSTALL FUEL FILTER ELEMENT ASSEMBLY

a.

Check and clean the installation surface of the fuel filter assembly.


b.

Apply fuel to the gasket of a new fuel filter element assembly.


c.
A131642

Lightly screw the fuel filter element assembly into place, and tighten it until the gasket comes into contact with the seat.


d.

Tighten it an additional 3/4 turn by hand.


Hide 11.INSTALL FUEL FILTER ASSEMBLY

a.

Install the fuel filter assembly with the bolt.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


b.

Connect the fuel hose, No. 1 fuel hose, No. 2 fuel hose and No. 3 fuel hose to the fuel filter assembly, and slide the 4 clamps to secure the hoses.


c.

Connect the level warning switch connector.


Hide 17801 13.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17705 14.INSTALL AIR CLEANER CAP SUB-ASSEMBLY