Home › Engine / Hybrid System › 1AD-FTV FUEL › SUCTION CONTROL VALVE › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008413 1AD-FTV FUEL _0049271 SUCTION CONTROL VALVE A

1AD-FTV FUEL  SUCTION CONTROL VALVE  REMOVAL  


PROCEDURE

Hide 17705 2.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 3.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 5.CLEAN SUCTION CONTROL VALVE ASSEMBLY AND SURROUNDING AREA

a.

Using cleaning spray or a brush, clean the suction control valve assembly and the surrounding area.

NOTICE:

After cleaning with cleaning spray, do not blow air as doing so will cause any dust or sand in the surrounding area to become airborne and adhere to the cleaned area.



Hide 6.REMOVE SUCTION CONTROL VALVE ASSEMBLY

NOTICE:
·

Before replacing the suction control valve assembly, be sure to clean the surrounding area.

·

When replacing the suction control valve assembly, make sure that your hands are clean and do not use gloves, etc.



a.

Disconnect the suction control valve connector.


b.
A228326

Using a 5 mm hexagon wrench, remove the 2 bolts, suction control valve assembly and O-ring from the fuel supply pump assembly.

NOTICE:
·

Do not reuse the suction control valve assembly or O-ring once they have been removed.

·

Make sure that the O-ring does not remain attached to the fuel supply pump assembly.