Home › Drivetrain › GF1A TRANSFER / 4WD / AWD › DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM › 2012.12–2015.10
RM3090E _52 Drivetrain _008760 GF1A TRANSFER / 4WD / AWD _0048749 DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM D

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM  CALIBRATION  


DESCRIPTION


a.

w/o VSC:

When the 4WD ECU assembly is replaced with a normal one from another vehicle or the deceleration sensor is replaced, perform calibration.

w/ VSC:

When the 4WD ECU assembly is replaced with a normal one from another vehicle or the acceleration sensor (airbag sensor assembly) is replaced, perform calibration.


b.

Follow the chart to perform calibration.

Part Replaced Necessary Operation
4WD ECU assembly (When replaced with a normal one from another vehicle) When using GTS:
Clear zero point calibration data
When using SST check wire:
Clear zero point calibration data (w/o VSC)
Perform vehicle stability control system calibration (w/ VSC)
Click here(Click here)
Deceleration sensor (w/o VSC) Clear zero point calibration data
Acceleration sensor (airbag sensor assembly) (w/ VSC) When using GTS:
1.

Clear zero point calibration data

2.

Perform vehicle stability control system calibration

Click here(Click here)


When using SST check wire:
Perform vehicle stability control system calibration
Click here(Click here)

HINT:

When the 4WD ECU assembly is replaced with a new one, calibration is unnecessary.




PERFORM CALIBRATION (When Using GTS)


a.

Clear the zero point calibration data.

i.

Turn the ignition switch off.


ii.

Connect the GTS to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the GTS on.


v.

Enter the following menus: Chassis / Four Wheel Drive / Utility / Reset Memory.

Chassis > Four Wheel Drive > Utility
Tester Display
Reset Memory
50005 118 2119

vi.

Operate the GTS to clear the data.




PERFORM CALIBRATION (When Using SST Check Wire)


a.

w/o VSC:

Clear the zero point calibration data.

i.

Turn the ignition switch off.


ii.

for manual transaxle:

Check that the shift lever is in neutral and apply the parking brake.

except manual transaxle:

Check that the shift lever is in P and apply the parking brake.


iii.

Turn the ignition switch to ON.


iv.

The warning light and indicator light come on for 4 seconds to indicate that the initial check is completed.


v.
C166029
0.135,1.01 0.563,1.313 0.427,0.302 1.635,0.875 1.854,0.313 false 1.792,1.917 1.625,1.469 false 1.823,0.135 2.188,0.313 0.365,0.177 10 false CG 0.125,0.073 0.344,0.25 0.219,0.177 10 false *a 0.208,1.073 0.531,1.25 0.323,0.177 10 false G14 1.771,1.927 2.135,2.104 0.365,0.177 10 false TS
*a Front view of DLC3


Using SST, connect and disconnect terminals 12 (TS) and 4 (CG) of the DLC3 4 times or more within 8 seconds.

SST
09843-18040  


vi.

Turn the ignition switch off.



b.

w/ VSC:

Calibrate the 4WD ECU assembly by performing vehicle stability control system calibration.