Home › Drivetrain › GF1A TRANSFER / 4WD / AWD › DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM › 2012.12–2015.10
RM3090E _52 Drivetrain _008760 GF1A TRANSFER / 4WD / AWD _0048749 DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM D

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


a.

When a DTC is stored, the 4WD ECU assembly stores the current vehicle state as Freeze Frame Data.

HINT:

Freeze Frame Data at the time a DTC is stored:

·

When the 4WD ECU assembly stores data at the time a DTC is stored, no updates will be performed until the data is cleared.

·

"Number of IG ON" is not stored as Freeze Frame Data.





CHECK FREEZE FRAME DATA


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes.

Chassis > Four Wheel Drive > Trouble Codes
50001 118

e.

According to the display on the GTS, select the trouble code data display with Freeze Frame Data.

Chassis > Four Wheel Drive
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) No large fluctuations when driving at a constant speed.
Forward and Rearward G Forward and rearward G Min.: -25.10 m/s2
Max.: 24.90 m/s2
- Changes in proportion with acceleration during acceleration/deceleration.
FR Wheel Speed Front wheel speed sensor RH reading Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) No large fluctuations when driving at a constant speed.
FL Wheel Speed Front wheel speed sensor LH reading Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) No large fluctuations when driving at a constant speed.
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) No large fluctuations when driving at a constant speed.
RL Wheel Speed Rear wheel speed sensor LH reading Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) No large fluctuations when driving at a constant speed.
Accelerator Opening Angle % Accelerator pedal depression amount Min.: 0%
Max.: 127%
When the accelerator pedal is released: 0% Changes in proportion to the movement of the pedal during accelerator pedal operation.
Real Engine Torque Real engine torque Min.: -1024 Nm
Max.: 1023 Nm
- -
Steering Angle Sensor Steering angle sensor Min.: - 3276.8°
Max.: 3276.7°
Left turn: Increase
Right turn: Decrease
-
IG1 Voltage Value IG1 voltage value Min.: 0 V
Max.: 20 V
Ignition switch ON: 11 to 14 V -
Stop Light SW Stop light switch ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW Parking brake switch ON or OFF OFF: Parking brake released
ON: Parking brake applied
-
Number of IG ON Number of operations of ignition switch being turned ON after storing Freeze Frame Data 0 to 31 0 -
Yaw Rate Sensor Yaw rate value Min.: -128°/s
Max.: 127°/s
w/o VSC:

0°/s


w/ VSC:

Vehicle stopped: 0°/s

Turning right: -128 to 0°/s

Turning left: 0 to 127°/s


-
Lateral G Lateral G Min.: -25.10 m/s2
Max.: 24.90 m/s2
- Changes in proportion with the pedal movement speed when the brake pedal is being operated.


CLEAR FREEZE FRAME DATA


NOTICE:

Clearing the DTCs will also clear the Freeze Frame Data.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.