Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM(for Start Function)
RM3090E _58 Vehicle Interior _008690 THEFT DETERRENT / KEYLESS ENTRY _0049280 ENTRY AND START SYSTEM(for Start Function) C

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  B2277  Detecting Vehicle Submersion  


DESCRIPTION

This DTC is stored when a malfunction in the water submersion detection circuit in the certification ECU (smart key ECU assembly) is detected.

HINT:

When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
B2277 Detecting Vehicle Submersion The water submersion detection circuit in the certification ECU (smart key ECU assembly) detects water submersion (1-trip detection logic*).
·

Submersion of certification ECU (smart key ECU assembly) in water

·

Certification ECU (smart key ECU assembly)


Wait 300 seconds after connecting the cable to the negative (-) battery terminal.

*: Only detected while a malfunction is present.

Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
The engine switch cannot be turned off and the engine cannot be started. -

Related Data List and Active Test Items
DTC Data List Item Active Test Item
B2277 - -

CAUTION / NOTICE / HINT

NOTICE:
·

When using the GTS with the engine switch off to troubleshoot:

Connect the GTS to the DLC3 and turn a courtesy light switch on and off at 1.5 second intervals until communication between the GTS and vehicle begins.

·

The entry and start system (for Start Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Click here Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the entry and start system (for Start Function) after confirming that the communication systems are functioning properly.

·

Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Start Function) precaution.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Start Function)>PRECAUTION

·

After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.



HINT:

Before proceeding with troubleshooting, check if there are any signs of water damage to the power management control ECU. If there are any signs of water damage, replace the power management control ECU and take measures against the cause of the water damage.


PROCEDURE

1.CHECK WATER DAMAGE
a.

Check the power management control ECU, surrounding parts, wire harnesses and connectors for any signs of water damage.

Result:
Proceed to
No signs of water damage
Signs of water damage




No signs of water damage

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

Signs of water damage

TAKE MEASURES AGAINST CAUSE OF WATER DAMAGE AND REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)