23710B
1.INSPECT EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
| *1 | Component without harness connected
(Exhaust Fuel Addition Injector Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 7.1 to 7.9 Ω |
The temperature indicated in "Condition" is the temperature of the exhaust fuel addition injector assembly.
If the result is not as specified, replace the exhaust fuel addition injector assembly.