Home › Engine / Hybrid System › 2AD-FHV EMISSION CONTROL › DIFFERENTIAL PRESSURE SENSOR
RM3090E _51 Engine / Hybrid System _008736 2AD-FHV EMISSION CONTROL _0049297 DIFFERENTIAL PRESSURE SENSOR A

2AD-FHV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89480A 1.INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

a.
A273037
0.667,4.083 0.667,3.917 0.667,3.917 0.948,3.281 true 3.083,4.167 3.083,4 3.083,4 2.875,3.271 true 0.802,0.615 1.115,0.771 0.313,0.156 10 *a 0.333,3.354 0.646,3.51 0.313,0.156 10 *b 0.604,4.073 0.917,4.229 0.313,0.156 10 *1 3.01,4.167 3.323,4.323 0.313,0.156 10 *2 0.875,2.469 1.188,2.625 0.313,0.156 10 *a 2.781,2.5 3.094,2.656 0.313,0.156 10 *a 1.865,3.354 2.177,3.51 0.313,0.156 10 *b 0.479,2.313 0.635,2.51 0.156,0.198 10 A 1.396,1.365 1.552,1.563 0.156,0.198 10 A 2.344,2.313 2.5,2.51 0.156,0.198 10 B 1.896,1.385 2.052,1.583 0.156,0.198 10 B 1.021,2.865 1.479,3.063 0.458,0.198 10 30° 0.708,2.865 1.167,3.063 0.458,0.198 10 30° 2.125,3.042 2.583,3.24 0.458,0.198 10 60° 2.115,3.708 2.573,3.906 0.458,0.198 10 60°
*1 Paint Mark (Yellow)
*2 Paint Mark (Red)
*a Front Side of Vehicle
*b LH Side


Connect the vacuum transmitting hose assembly and No. 2 vacuum transmitting hose assembly to the differential pressure sensor assembly, and slide the 2 clamps labeled A and B to secure the hoses.

NOTICE:

Connect the vacuum transmitting hoses so that the painted marks of the vacuum transmitting hose assembly and No. 2 vacuum transmitting hose assembly are as shown in the illustration.



b.

Install the differential pressure sensor assembly with the nut.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Connect the differential pressure sensor connector.