Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for HDD) › 2012.12–2014.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0048745 NAVIGATION SYSTEM(for HDD) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for HDD)  Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the data signal from a USB device to the navigation ECU sub-assembly via this circuit.

WIRING DIAGRAM

E235206E08
1.042,1.792 1.479,1.958 0.438,0.167 10 G145 1.042,1.969 2.219,2.344 1.177,0.375 10 No. 1 Stereo Jack Adapter Assembly 5.156,1.792 5.656,1.958 0.5,0.167 10 G149 5.198,1.313 5.896,1.479 0.698,0.167 10 UDO+ 5.01,1.229 5.219,1.396 0.208,0.167 10 3 5.198,0.76 5.781,0.958 0.583,0.198 10 UDO- 5.01,0.677 5.188,0.844 0.177,0.167 10 2 1.604,1.313 2.021,1.479 0.417,0.167 10 UDO+ 2.063,1.229 2.271,1.396 0.208,0.167 10 3 1.604,0.76 2.021,0.927 0.417,0.167 10 UDO- 2.063,0.677 2.271,0.844 0.208,0.167 10 2 5.156,1.958 6.146,2.333 0.99,0.375 10 Navigation ECU Sub-assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the G149 navigation ECU sub-assembly connector.


b.

Disconnect the G145 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G149-2 (UDO-) - G145-2 (UDO-) Always Below 1 Ω
G149-3 (UDO+) - G145-3 (UDO+) Always Below 1 Ω
G149-2 (UDO-) - Body ground Always 10 kΩ or higher
G149-3 (UDO+) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR