These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Sending Malfunction (Navigation to APGS) | CAN bus connection error | CAN communication system |
| U0100 | Engine ECU Communication | CAN reception error | CAN communication system |
| U0126 | Steering Sensor Communication | CAN reception error | CAN communication system |
| U0129 | VSC(ECB)ECU Communication | CAN reception error | CAN communication system |
| U0131 | Lost Communication with Electric Power Steering ECU | CAN reception error | CAN communication system |
| U0140 | Lost Communication with Body Control Module | CAN reception error | CAN communication system |
| U0155 | Meter ECU Communication | CAN reception error | CAN communication system |
Clear the DTCs.
Recheck for DTCs and check if the same DTCs are output again.
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTCs are output
for LHD:
for RHD: