Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
58903A
1.REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY
Detach the 4 claws and 2 clips and remove the console rear end panel sub-assembly.
58905
2.REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY (except Slide Console Type)
| *1 | Plastic-faced Hammer |
| *2 | Shaft |
Using a plastic-faced hammer, tap the shaft in lightly and then pull it out from the rear console box sub-assembly.
Remove the 2 bushes and console compartment door sub-assembly.
58905
3.REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY (for Slide Console Type)
Remove the 4 screws and console compartment door sub-assembly.
58908A
4.REMOVE CONSOLE COMPARTMENT DOOR LOCK SUB-ASSEMBLY
Remove the 2 screws and console compartment door lock sub-assembly from the console compartment door sub-assembly.
58808
5.REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)
Detach the 4 hooks and remove the shifting hole cover sub-assembly from the upper console panel sub-assembly.