Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM3090E _52 Drivetrain _008762 AXLE AND DIFFERENTIAL _0049346 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43212 1.INSTALL STEERING KNUCKLE LH

a.

Secure the steering knuckle in a vise.

NOTICE:

When using a vise, do not overtighten it.



b.

Install the front brake dust cover to the steering knuckle.


c.

Install the front axle hub sub-assembly with the 4 bolts.

Torque:
96 N*m (979 kgf*cm, 71 ft.*lbf)

NOTICE:

Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.



Hide 43340A 2.INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH

Hide 43502C 3.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH