Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
43502H
2.REMOVE FRONT AXLE SHAFT NUT LH
3.DISCONNECT FRONT SPEED SENSOR LH
47313A
4.DISCONNECT FRONT FLEXIBLE HOSE
45047
5.DISCONNECT TIE ROD END SUB-ASSEMBLY LH
6.DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
43512
7.REMOVE FRONT DISC
48069
8.DISCONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
9.REMOVE FRONT AXLE ASSEMBLY LH
43340A
10.REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH
Secure the front axle assembly between aluminum plates in a vise.
When using a vise, do not overtighten it.
Remove the cotter pin and nut.
| *a | 1 mm (0.0394 in.) |
Install SST to the front lower ball joint as shown in the illustration.
Make sure that the clearance measurement between SST and the front axle assembly is 1 mm (0.0394 in.).
| *a | Molybdenum Grease Application Area |
| *b | Turn |
Using SST, remove the front lower ball joint from the front axle assembly as shown in the illustration.
Apply molybdenum grease to the bolt threads and the tip of SST.
Install SST so that A and B are parallel.
Be sure to turn the part indicated in the illustration with a wrench.
Do not damage the front lower ball joint dust cover.
Be sure to tie the string of SST to the vehicle to prevent SST from dropping.